Test dryer heating element how to#

Important tip: when you test the heating element, ensure you also check (for continuity)between the posts as well as between the post & the element case itself. Now, if you get a reading that is off from this range or your display does not change on any of the terminals, then your element might be damaged and you should replace it. If the element has continuity, steps 3 and 4 above will each produce a reading of between 5 and 50 ohms.Repeat step 3 on the other wire terminals.Set your multimeter to the lowest ohm reading.In that event, you should replace the whole element. Note: it is possible for one terminal to have continuity and the other to lack. Of course, your heating element could be gone if you do not hear any beeping sound (meaning there’s no continuity). If there’s continuity, steps 3 and 4 above will make your multimeter beep.Repeat step 3 for the other wire terminals.Place one of the probes on the common wire terminal.Set your multimeter to the continuity setting.Just know that this is the terminal that has 2 or more wires attached to it(The other terminals will have only 1 wire attached to them).

Test dryer heating element how to#

How to test heating elements with 3 or more terminalsįor such terminals, you will first need to find the common wire terminal. If not- If your display does not change or you get a reading that is far from this range- then your element could be damaged and you likely have to replace it.

Here is the thing: If your element has continuity, you should get a reading of between 5 and 50 ohms. Next, place the probes on the wire terminals. If your multimeter does not have the continuity setting, then this is the setting you should use.įirst, set your multimeter to the lowest ohm setting. Otherwise, if there is no continuity, then there’s a decent chance that the heating element is gone and you need to change it out. Now, if the element has continuity, your multimeter should make a beeping sound. You then place the probes on the wire terminals. If your multimeter has this option, turn it to the continuity setting. Here is the procedure if your dryer heating element has 2 terminals How to test heating elements with 2 terminals Now, if none of the coils appear broken, you should use a multimeter to test the element for continuity. Quick Tip: Make sure you first disconnect and remove the heating element from your dryer before testing it. So follow these steps to test the heating element of your dryer to be sure it is the root cause of your dryer problems- the steps work for nearly all dryer models( from Samsung to LG to Whirlpool). If so, then, your heating element could be shorted and will require to be replaced. How to test heating element in dryer įirst check to see if any of the coils are detached or broken. I will show you how to test heating element in dryer in this article- testing is important because it is the only way you can be sure the part is the culprit if your appliance is acting up(if so, it needs to be replaced). As an Amazon affiliate, we earn a commision from qualifying purchases.